Kitchen Cabinets. Monday , February 12th , 2018 - 15:43:47 PM
Custom-made kitchen cabinets are good because you can set you own style and preference that would be perfect for your kitchen. However, these can be expensive too. The good news is that you no longer need to spend lots of money for custom-made kitchen because there are lots of RTA cabinets for your kitchen that will surely satisfy your style. Here are some examples of these cabinets: 1. Shaker Kitchen Cabinets - do you prefer the Early American look? This particular style is suitable for traditional type of kitchen and can also be perfect for modern houses. They offer handcrafted look that will surely impress your guests. These cabinets come in natural wood colors in any stains so we can say that the color can easily blend in different furniture in the kitchen.
2. Now that you have the top of the base cabinets marked, measure up another 19 1/2 inches and a level line across the wall to indicate the bottom of the wall cabinets. Lightly mark each cabinets dimensions and placement on the wall to make sure that your original layout is correct. 3. Use a stud finder to locate the wall studs. Use a pencil to mark the stud locations at least 6 inches above and below the line for the bottom of the wall cabinets. Draw straight vertical lines between the top and bottom marks to indicate the center of the studs. 4. If you decided to go with the piece of 1 x 3 lumber, now is where you will use (if you decided to go with the U-shaped frame, it will come into play after all your lines are laid out). Screw a temporary 1 x 3 support rail to the wall, aligning the top edge of the rail with the line for the bottom edge of the wall cabinets. Attach it by driving 3 or 4 two inch screws through the rail into the wall studs. 5. Now that we have all the lines marked, it is time to start installing your kitchen cabinets.
6. Now we are going to move onto the cabinets on either side of the corner cabinet. As you install each one, use the clamps to secure each cabinet to the neighboring cabinet and then check it for plumb with your level. On faceframe cabinets, it is a good idea to drill two 1/8 inch pilot holes through the sides of the faceframe and use screws. In this case, with frameless, ready-to-assemble kitchen cabinets we are going to screw through the plywood sides and use shims in between the cabinets to ensure a tight fit and make sure that the cabinet faces are plumb. 7. After all the wall cabinets are in place, install the corner or end base case cabinet.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does power8team claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.