Kitchen Cabinets. Monday , February 12th , 2018 - 16:12:47 PM
Use shims where needed to level the cabinet and raise it up to the line which indicates the high point of the floor. Be sure it is level from front to back and from side to side, then screw it to the wall studs. If you dont have a diagonal corner cabinet or blind base cabinet in the corner, push the adjoining cabinet into place and clamp the two units together. Add a filler strip if needed to allow the doors and drawers enough clearance to open and close properly. If necessary, tap shims under the cabinet and behind it to adjust for plumb and level. 8. Drive screws through the cabinet back (and shims) into the wall studs. Trim any excess material from the shims with a sharp chisel or knife. Continue to add adjoining cabinets in this manner, joining them the same way you connected the wall cabinets in step 6.
This is very inexpensive compared to cabinet replacement and can improve with dramatic effect the look of your kitchen. For the best results, a professional should paint or stain the cabinets. Great results can be achieved by a trained refinishing professional, inexpensively. However a DIY job is possible, if you have the time and tools you can easily refinish your own kitchen cabinets and save even more. Refacing kitchen cabinets is more expensive than refinishing cabinets but still a fraction of the cost to replace them. Here is how it works, the old cabinet doors and drawers are removed, stripped, and inspected for damage then the door and drawer fronts are replaced with new surfaces ranging from new wood veneer to laminate. The cabinet frames and exterior surfaces are covered or refaced to match and the inside of the cabinets are cleaned and painted to complete kitchen cabinet refacing.
6. Now we are going to move onto the cabinets on either side of the corner cabinet. As you install each one, use the clamps to secure each cabinet to the neighboring cabinet and then check it for plumb with your level. On faceframe cabinets, it is a good idea to drill two 1/8 inch pilot holes through the sides of the faceframe and use screws. In this case, with frameless, ready-to-assemble kitchen cabinets we are going to screw through the plywood sides and use shims in between the cabinets to ensure a tight fit and make sure that the cabinet faces are plumb. 7. After all the wall cabinets are in place, install the corner or end base case cabinet.
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does power8team claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.