Kitchen Cabinets. Monday , February 12th , 2018 - 16:34:14 PM
2. Now that you have the top of the base cabinets marked, measure up another 19 1/2 inches and a level line across the wall to indicate the bottom of the wall cabinets. Lightly mark each cabinets dimensions and placement on the wall to make sure that your original layout is correct. 3. Use a stud finder to locate the wall studs. Use a pencil to mark the stud locations at least 6 inches above and below the line for the bottom of the wall cabinets. Draw straight vertical lines between the top and bottom marks to indicate the center of the studs. 4. If you decided to go with the piece of 1 x 3 lumber, now is where you will use (if you decided to go with the U-shaped frame, it will come into play after all your lines are laid out). Screw a temporary 1 x 3 support rail to the wall, aligning the top edge of the rail with the line for the bottom edge of the wall cabinets. Attach it by driving 3 or 4 two inch screws through the rail into the wall studs. 5. Now that we have all the lines marked, it is time to start installing your kitchen cabinets.
9. If your cabinets end up butting against another wall, you may need a filler strip to make up the last few inches. If you have custom cabinets, they should have been built to fill this gap, but if you are using stock or RTA Kitchen Cabinets the filler strip may be needed. If you do need to use a filler strip, leave the last cabinet detached from the other cabinets. Clamp a straightedge to the face of the nearest installed unit, extending far enough for you to put alignment marks on the end wall. Allow a 3/4" offset behind those marks (for the thickness of the filler piece) and fasten a cleat to the wall. Then install and fasten the last cabinet and measure the gap between its face frame and the wall.
Now that you have your new kitchen cabinets, you are ready to move on to the next big step.....Installing your kitchen cabinets. While the actual installation of the Kitchen Cabinets isntall that hard, the critical first step is measuring and marking out where the cabinets will go. By placing layout markings on the walls and floors, it will not only help you with kitchen cabinet placement and stud locations, but it will also help you locate where adjustments and shims will be required. Before we get started there are a couple of items that you will need for the project: Pencil Level or Laser Level Drill Tape Measure Stud Finder Clamps 1" x 3" Piece of lumber (6-8 in length) or an Inverted U-shaped frame (see notes below) Shims Screws (long enough to go 1 1/2 into the studs) Utility knife or chisel Marking Compass An extra set of hands (you may have to bribe one of your friends).
Any content, trademark/s, or other material that might be found on this site that is not this site property remains the copyright of its respective owner/s. In no way does power8team claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.